Category Archives: Parametric Design

This is the base design and is intended to be used with the 20mm Universal Camera Mount. Guide for 3D printing the gimbal design here. Files on Thingiverse: https://www.thingiverse.com/thing:5372831 Design commissioned by: Alain Morla

This is the base design is intended to be used with the 20mm Universal Camera Mount. Guide for 3D printing the gimbal design here. Files on Thingiverse: https://www.thingiverse.com/thing:5353793 Design commissioned by: Hyeong Seob Kim

This is the base design is intended to be used with the 18mm Universal Camera Mount. This frame design forced this gimbal to use a 18mm bearing housing meaning it is not compatible with the standard camera mount options shown elsewhere on the site. Guide for 3D printing the gimbal design here. Files on Thingiverse:Continue reading “FPV Gimbal – Rebel Basic – LDX-218”

This is the base design is intended to be used with the Universal Camera Mount. I have made a ‘vertical servo’ and ‘push through’ base design, I prefer the ‘push though’ but both had advantages/disadvantages. Guide for 3D printing the gimbal design here. Files on Thingiverse: https://www.thingiverse.com/thing:5332112 Design commissioned by: Mokaframe – Mokaframe.com

This is the base design will fit any of the Mr.Croc frames and is intended to be used with the Universal Camera Mount. Guide for 3D printing the gimbal design here. Files on Thingiverse: https://www.thingiverse.com/thing:5274072

This frame design forced this gimbal to use a 18mm bearing housing meaning it is not compatible with the standard camera mount options shown elsewhere on the site. Guide for 3D printing the gimbal design here. Files on Thingiverse: https://www.thingiverse.com/thing:5244636 **This design is currently untested, but should work, will update once it has been tested**

This is the base design and is intended to be used with the Universal Camera Mount. Guide for 3D printing the gimbal design here. Files on Thingiverse: https://www.thingiverse.com/thing:5240391 **This design is currently untested, but should work, will update once it has been tested** Design commissioned by: Alejandro Ibanez

This is the base design and is intended to be used with the Universal Camera Mount. Guide for 3D printing the gimbal design here. Files on Thingiverse: https://www.thingiverse.com/thing:5186805

This is the base design and is intended to be used with the 20mm Universal Camera Mount. Guide for 3D printing the gimbal design here. Files on Thingiverse: https://www.thingiverse.com/thing:5180747

This design has two options, one with the servo in horizontal orientation and one in vertical orientation. Both designs allow very high uptilt at or greater than 45 degrees. This is the base design and is intended to be used with the Universal Camera Mount. Guide for 3D printing the gimbal design here. Files onContinue reading “FPV Gimbal – Project 399 Super G / Super G Plus / Super G 10″ – LDX-218”